PURE M3700 Bedienungsanleitung PDF herunterladen (Seite 87)

M3700 user manual

12. Appendix

12.1 Appendix A: Phone-Set Command

Pick up the handset and listen for the dialing tone. Dial “##0000 and listen for three consecutive

tones before setting the following parameters. After input the parameters, please dial ‘# to end the

configuration.

Note: If Dialing Mode is configured to Transparent, (refer to section

8.1 Dialing Plan) then all digits

you dial is passed to SIP Proxy and all Phone-Set Command is disabled.

Command Description

Parameters

01 IP State 0 : static; 1: DHCP; 2: PPPoE

02 IP Address xxx*xxx*xxx*xxx

03 Subnet Mask xxx*xxx*xxx*xxx

04 Default Gateway xxx*xxx*xxx*xxx

05 Primary DNS Server

xxx*xxx*xxx*xxx

06 Second DNS Server

xxx*xxx*xxx*xxx

07 Select Signaling Port 0~65535

08 Select RTP Base Port 0~65534 (limit to even port number only)

09 PPPoE username User name (use the mapping table to map

character into digits)

10 PPPoE password Password (use the mapping table to map

character into digits)

11 DND Do not Disturb, this line accept dial out call only.

All incoming call is terminated. 0 : Disable ; 1:

Enable

12 SIP Forward State 0 : Disable ; 1: Enable; 2: Busy; 3: No Answer

13 SIP Forward To

Number

The SIP number that this line will forward to. The

Forward To address is "key in phone-set

number@SIP proxy registered". For example,

[email protected].com, 73796 is the number

you key-in by phone-set. fwd.pulver.com is the

registered proxy of this gateway.

14 Change Service Port 1:FTP; 2:HTTP 3:Telnet (Port: 0-65535)

DCC NO. 91710015011

1 2 ... 82 83 84 85 86 87 88 89 90 91 92

Keine Kommentare

PURE M3700 Bedienungsanleitung Seite 87