PURE M3700 Bedienungsanleitung PDF herunterladen (Seite 20)

6.2.1 Static IP Mode

The following table shows an example.

IP Address 210.67.96.121

Subnet Mask 255.255.255.248

Default Gateway 210.67.96.120

Web Management

Password

123

Using the information contained in the example above. The procedure is as follows:

1. Connect the unit to a suitable Power source.

2. Connect a traditional phone set to the “FXS” connector located on the rear panel.

3. When the CPU/ACT light is on, pick up the phone to hear the dialing tone.

4. ##0000 ; you should hear three short tones.

5. 010

# ; the digit “0” is used to enable “manual” IP mode.

6. 02210*67*96*121

# ; IP address.

7. 03255*255*255*248

# ; Subnet Mask.

8. 04210*67*96*120

# ; Default Gateway.

9. 15123

# ; “123” is the web management password.

10. 981

# ; Warm-restarts.

11. Hang up the phone. The system should now restart.

You can also use console to configure IP address.

(For Telnet, From Windows, Start Æ Run Æ Telnet 192.168.0.2 (192.168.0.2 is the default IP of this

machine.)

SIP-RG>enable

SIP-RG#configure

Enter configuration commands, one per line. End with CNTL/Z

SIP-RG(config)#ip state user

SIP-RG(config)#ip address 210.67.96.121 255.255.255.248

System need to restart

SIP-RG(config)#ip default-gateway 210.67.96.120

SIP-RG(config)#exit

SIP-RG#restart

This command resets the system. System will restart operation code agent.

Reset system, [Y]es or [N]o? Yes

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 91 92

Keine Kommentare

PURE M3700 Bedienungsanleitung Seite 20