PURE M3700 Bedienungsanleitung PDF herunterladen (Seite 19)

M3700 user manual

6.1.2 System console settings (Only 3704/3708/3716)

The Instructions below is to set Region ID from Console terminal or Telnet

(For Telnet, From Windows, Start Æ Run Æ Telnet 192.168.0.2 (192.168.0.2 is the default IP of this

machine)

(In the example, the Region ID is changed to 07 for China)

SIP-RG>enable

SIP-RG #configure

Enter configuration commands, one per line. End with CNTL/Z

SIP-RG(config)#regional_id 07

SIP-RG(config)#exit

SIP-RG#delete nvram region_specific

This command resets the system with factory defaults.

All system parameters will revert to their default factory settings. All static

and dynamic addresses will be removed.

Reset system with factory defaults, [Y]es or [N]o? Yes

Note:

Here is some related command for your reference

The following instruction reset all setting:

“delete nvram”

The following instruction reset all setting except IP address:

“delete nvram keep_ip”

6.2 IP Address Settings

We recommend using a traditional phone to configure the unit’s parameters, as this is the easiest

way. The following two sections contain the procedures used to configure the unit according to how

you obtain your IP address (Static IP; DHCP or PPPoE).

Every time you set a parameter item and press the “#” key to complete it, a successful setting will be

confirmed by three equal tones in succession. If your setting is unsuccessful you will be prompted

with one long tone.

DCC NO. 91710015011

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 91 92

Keine Kommentare

PURE M3700 Bedienungsanleitung Seite 19