Pure Evoke-1 Bedienungsanleitung PDF herunterladen (Seite 12)

Autotune local - scans all frequencies in the UK channel allocation. This should only take a few seconds.

Autotune full - scans the full range of digital frequencies in Band III. This may take a minute or more.

1. Ensure your EVOKE-1 is switched on and the aerial is connected and fully extended.

2. Push and release the Autotune button once for local scan or hold down for around two seconds for a full scan.

Note You can cancel Autotune by pushing the Autotune button again during the tuning process.

The display will indicate tuning is underway. When finished, the EVOKE-1 will return to the station you were

listening to and you will hear it through the speaker. All the stations found are now stored in the unit and you can

select another station as described in Selecting a station on page 9.

If no stations are found, you see the message ‘No stations available’ and the display shows an option menu,

see If no stations are found during the autotune on page 7 for details of this menu. Check your aerial is fully

extended and try one of the available tuning options.

Retuning your unit

You can re-tune your unit at any time using the autotune process. You may wish to do this if a new multiplex is launched

or you move your unit to another room. You do not need to perform an autotune to pick up new stations within a

multiplex you are listening to as your EVOKE-1 monitors and refreshes the list of available stations automatically when

you tune to a station in that multiplex. The following two options are available:

Adjusting the volume

Once you have tuned your EVOKE-1 you can adjust the volume using the Vol knob.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Keine Kommentare

Pure Evoke-1 Bedienungsanleitung Seite 12