PURE Contour i1 Air Bedienungshandbuch PDF herunterladen (Seite 6)

Switching between Sleep, Standby and On

Contour has three power modes, Standby, Sleep and On. In Standby, Contour uses minimal power

(Status LED is bright red). In Sleep mode, Contour remains connected to the wireless network

(once attached) and is waiting for a source to be selected (the Status LED is dimmed red).

To enter Sleep mode, press Standby. Contour will automatically enter Sleep mode if it does not

receive any audio from AirPlay or an iPod/iPhone/iPad.

Once in Sleep mode, press Standby to switch to On.

To enter Standby, press and hold Standby for four seconds on Contour, or the remote until the

Status LED is bright red. Press Standby to switch straight to On. Contour will ﬂash red for around

30 seconds, pause, and then return to the state that Contour was in before Standby.

Network setup

Contour can be connected to your network using a wireless or wired connection.

We recommend using the wireless connection method, which allows you to position your Contour

anywhere within range of your wireless connection. See page 7 for more information.

To use the wired connection method, connect an Ethernet cable between the Ethernet port on the

back of Contour and one of the available Ethernet ports on your router. You might want to use this

method if you experience sound quality problems or if your Contour is located near your router.

See page 10 for more information.

Front panel Status LED

When Contour is powered, the Status LED is visible through the front speaker mesh. The Status

LED is also used to indicate the various states of Contour, by colour.

Red Standby (bright) / Starting up (bright ﬂashing) / Sleep (dimmed)

Blue iPod/iPhone/iPad dock is active (ﬂashing indicates that the connection to

the docked product is preparing and also indicates remote activity)

White AirPlay is active (fast ﬂashing indicates remote activity) (slow ﬂashing

indicates network connectivity problems)

Pink Aux In is active (fast ﬂashing indicates remote activity)

Blue/Green (Alternate ﬂashing) Temporary wireless network setup

Cyan Flashing indicates a software error

Amber Updating software

Note: For quick reference, there is a sticker on the base of Contour which indicates the most

common Status LED states.

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Keine Kommentare

PURE Contour i1 Air Bedienungshandbuch Seite 6