PURE Contour i1 Air Bedienungshandbuch PDF herunterladen (Seite 10)

Preparing Contour to use

AirPlay with an Ethernet cable

1. Connect an Ethernet cable from

the Ethernet port on the back of

Contour to your router.

2. Insert the connector of the mains

power adapter into the DC In

socket on the rear of Contour.

3. Plug in to the mains supply.

4. A network connection between your router and Contour will then be established automatically.

When the red Status LED on the front has stopped flashing, Contour is in Standby.

5. Press Standby on Contour or the remote control until Contour has AirPlay selected as its

input source. If the Status LED is steady white then AirPlay has been setup successfully. If the

Status LED is ﬂashing white, there is a problem with Contour’s network connection.

Note: See “Help” on page 24 for help with troubleshooting Contour network connectivity

issues.

6. Contour is now set up to use AirPlay with a wired connection. No further configuration is

required. See page 11.

18V DC

Typical Ethernet setup

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Keine Kommentare

PURE Contour i1 Air Bedienungshandbuch Seite 10