PURE M3700 Bedienungsanleitung Seite 22

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 92
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 21
can find them at section 12.4 Mapping table of characters used in PPPoE.
Example user name[email protected]Password123abThe procedure is below
1. Connect the phone to the unit
2. When CPU/ACT is light, pick up the phone and press
3. ##0000
You will hear 3 short tones.
4. 0938333732314068696*465742*46*46574#
Set user name[email protected]
5. 103132336162#
Set password is 123ab
6. 981#
Save and restart.
6.2.3.2 2. Use Console to configure (Only 3704/3708/3716)
You can also use console to configure IP address.
(For Telnet, From Windows, Start Æ Run Æ Telnet 192.168.0.2 (192.168.0.2 is the default IP of this
machine, change it if the IP is changed.)
SIP-RG>enable
SIP-RG#configure
Enter configuration commands, one per line. End with CNTL/Z
SIP-RG(config)#pppoe username [email protected]
SIP-RG(config)#pppoe password 123ab
SIP-RG(config)#exit
SIP-RG#restart
This command resets the system. System will restart operation code agent.
Reset system, [Y]es or [N]o? Yes
6.2.3.3 3. Use WEB Interface to configure:
You can configure the user name and password by using WEB interface. Follow the steps to finish
configuration.
Step 1: Using a traditional phone set to configure the web management password and phone
number
You will need to use a web browser to perform the PPPoE settings through the unit’s web based
management interface. To enter the web based management interface you must have a previously
configured password. Follow the next procedure to setup your password and phone number.
1. Connect the unit to a suitable Power source.
2. Connect a traditional phone set to the “Phone” connector located on the rear panel.
20
Seitenansicht 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 91 92

Kommentare zu diesen Handbüchern

Keine Kommentare