PURE M3700 Bedienungsanleitung PDF herunterladen (Seite 4)

the parts in the compartment where you put knife, fork and spoon. I did all parts at once 40°C “express mode” and

put half of one of those dish washer tabs in. Almost all parts were clean but some had still some muck on it that went

away when I dried them with a kitchen towel. I think I could have run the dishwasher a second time since “express

mode” doesn’t last very long but I just went ahead with the drying.

I cleaned the console surface with a wettish lint-free cloth and off the shelf dish liquid. To make cleaning easier and to

allow access to the pots and faders, I removed a quadro-channelstrip module and an 8 channel fader module. The

knobs had already been removed, so you just need to remove all the nuts from the pots, disconnect the line faders

from their respective PCBs and you’re good. Now you can clean the surface, and treat the pots and line faders with

DeoxIT Fader Lube. In addition to that I treated every switch / latch with contact cleaner. Fitting the cover over the

pots and switches was quite difficult. You need to be very careful not to bend or break something. Maybe it would

have been easier to completely remove the channelstrips from the console and pull one PCB at a time working from

the bottom instead of the top.

1 2 3 4 5 6 7 8 9 ... 30 31

Keine Kommentare

PURE M3700 Bedienungsanleitung Seite 4