PURE 9015TS Bedienungshandbuch PDF herunterladen (Seite 24)

TO DISASSEMBLE AND/OR MOVE

IN WINDY CONDITIONS - In severe wind conditions, the trampoline can be blown about. If

you expect windy weather conditions, the trampoline should be moved to a sheltered area or disas-

sembled. To ensure security in normal weather conditions, at least four (4) tie downs should be used.

Secure the trampoline frame to the ground. You can purchase an ANCHOR KIT for your trampoline

from Pure Fun, by visiting us on the web at www.pureglobalbrands.com or by calling 866-498-5269.

It is insufcient to secure only the legs of the trampoline to the ground as they can pull out the frame

sockets.

MOVING THE TRAMPOLINE - When moving the trampoline,aminimumofthreepeople

arerequired. All connecting points on the top rails should be securely and tightly wrapped with

weather resistant tape, such as duct tape. This will keep the frame intact during the move and prevent

the connector points from dislocating and separating. When moving, lift the trampoline slightly off the

ground and keep it horizontal to the ground. Never drag the trampoline. For any type of other move,

you should disassemble the trampoline. After any move please conduct a full safety inspection.

TO DISASSEMBLE:

ADULTS REQUIRED – A rubber mallet (not included) is required to disassemble some parts of the

trampoline.

1. Unattach the Enclosure Netting by unclasping the net bottom, and then releasing the hoops at the

top. Fold and store the net neatly where it will not be damaged or torn.

2. Remove the Enclosure hardware (Steel Jigs, Spacers, etc.) attaching the poles to the trampoline.

Store this hardware in a resealable zippered plastic bag for later reassembly. Remove and store the

poles in a dry, safe location where they will not present a tripping hazard or become damaged.

3. The Leg Extension (#6) and T-section assemblies (#4) are very tight and do not disassemble eas-

ily. We suggest you use a lubricant before beginning disassembly, specically on the areas where

the T-section and Leg Extension come together. You should lightly lubricate the visible joint by the

anged end of the Leg Extension, and apply a small amount of lubricant down the tube of the Leg

Extension. After applying lubrication, makesuretocleanexcesslubricantfromanyexte-

riorsurfacesusingadegreasingagent. Making sure there is no lubricant/grease on the Leg

extension exterior or the striking surface on the top rail, rmly grip or clamp the Leg Extension and

use a rubber mallet hit the top rail (#3) as shown to the right to disassemble this part.

Before reassembly or storage, any remaining lubricant must be fully cleaned with a degreasing agent

to ensure that the metal does not become damaged and that proper reassembly is achieved. (See

diagram 3.)

4. Do NOT disassemble the T-section (#4) and the top rail (#3); you can keep it as it is. It is not nec-

essary and it will make re-assembly easier. (See diagram 4)

3. 4.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30

Keine Kommentare

PURE 9015TS Bedienungshandbuch Seite 24