PURE 9015TS Bedienungshandbuch PDF herunterladen (Seite 20)

ReadtheSafetyWarninginformationonPage5beforeassemblingorusingyourEnclosure.

STEP1–PoleAssembly

A. Put the Upper (1) and Lower (2) sections of the Enclosure Poles together as shown below.

B. If necessary, attach the Pole Caps (8) to the tops of each Enclosure Pole.

C. Slide the Pole Covers (7) over the connected Enclosure Poles.

STEP2–AttachPolestoTrampoline

Note: Each Enclosure Pole requires 2xU-ShapedBar&MetalPlateassemblies to attach it to a

Trampoline leg. For positioning, the Enclosure Pole bottoms should reach the base of the Trampoline legs, with

the rubber feet securely on the ground.

A. As shown in Diagrams A1 and A2 below, place the Enclosure Pole against the Trampoline leg, making sure

to place the Spacers between each pole and leg.

B. Insert each U-shaped Bar through the plastic Spacers and into the Metal Plates. MAKE SURE that the

U-Shaped bar has its threaded ends facing towardsthecenterof the trampoline, and notoutwards.

Position the lower U-Shaped bar near the bottom of the Trampoline leg, but above any bend in the tubing.

Position the upper U-Shaped bar near the top of the Trampoline leg, but under the T-section ange (Pure Fun

Trampolines only), or other fastening array.

C. Secure U-Shaped Bar to Metal Plates with Nuts (4). Once fully tightened, place Safety Cap on each end.

D. Once the assembly has been completed properly, the support poles should resemble the bottom right

diagram below.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 29 30

Keine Kommentare

PURE 9015TS Bedienungshandbuch Seite 20