PURE 9015TS Bedienungshandbuch PDF herunterladen (Seite 14)

STEP2–TOPRAILANDSUPPORTASSEMBLY

1. Slide T-section (#4) onto attened end of the top

rail (#3). Ensure the hole on the side of the T-section

matches up with the hole on the side of the top rail. If

necessary, use the spring hook tool to help you widen

the T-section so it slides easily on the top rail. Repeat

for the other T-sections,

but do not connect the top rail sections together yet.

IMPORTANT:Theholesonthetoprail(Part

#3)needtobefacingDOWN.Youshouldnot

seethemwhenslidingtheT-Sectionsonto

thetoprail.

2.Makesureyouarenotabletoseeany

holesinthetoprailsectionsbeforepro-

ceeding.

Using the spring hook tool to hold the T-section closed,

t the leg tubes (#6) over the shut T-sections. You may

need to use a rubber mallet (not included) to assemble

the Leg Extensions down onto the T-sections so that

the anged part of the tube is resting as close as pos-

sible to the T-section base.

Note: The orientation of the leg tubes is important

(The anged end needs to t the T-sections). The

T-sections must be inserted into the wider end of the

leg tubes. Be careful not to pinch your ngers when

compressing the T-sections.

3. Connect two top rail sections together. Repeat for

the other top rail sections as shown in Fig 3.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 29 30

Keine Kommentare

PURE 9015TS Bedienungshandbuch Seite 14