Pure Contour 200i Air Bedienungsanleitung PDF herunterladen (Seite 11)

Switching between Sleep, Standby and On

Contour has three power modes, Standby, Sleep and On. In Standby, Contour

uses minimal power (Status LED is bright red). In Sleep mode, Contour remains

connected to the wireless network and waits for a source to be selected (Status

LED is dimmed red).

To enter Sleep mode, press Standby. Contour will automatically enter Sleep mode

after 15 minutes if it does not receive any audio from AirPlay or a docked iPod/

iPhone/iPad.

Once in Sleep mode, press Standby to switch to On.

To enter Standby, press and hold Standby for four seconds on Contour, or the

remote until the Status LED is bright red. Press Standby to switch straight to On.

Contour will ﬂash red for around 30 seconds, pause, and then return to the state

that Contour was in before Standby.

Network setup

Contour can be connected to your network using a wireless or wired connection.

We recommend using the wireless connection method, which allows you to

position your Contour anywhere within range of your wireless network. Contour

can be connected to your wireless network using Wi-Fi Network Login Sharing or

manually. See page 9 for more information.

To use the wired connection method, connect an Ethernet cable between the

Ethernet port on the back of Contour and one of the available Ethernet ports on

your router. You might want to use this method if you experience sound quality

problems or if your Contour is located near your router. See page 13 for more

information.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Keine Kommentare

Pure Contour 200i Air Bedienungsanleitung Seite 11